Home Autocostruzione Yagi Beam Dual Band 6&4 m
Italian (Italy)English (United Kingdom)

Main Menù

Scritto da IW0FFK   

Dual Band Yagi 6/4 meter Band

Dual band 6m-4m Yagi based on 6jxx6 from Sandro I0JXX.This antenna was optimized with the goal to minimize any changes in 6jxx6 impedance/lobes. The result is a 7 el on 70 MHz with a little loss of gain comparing with the other monobands of the same lenght.
If you don't have so much space on your mast, like me, a dual band antenna can be a nice solution.
I chose to separate the sources of the 2 antennas because i have two rigs attached.














The 4m antenna has an impedance of about 27 Ohm, so we must use a matching circuit. The easiest way is to use a quarterwave line of about 35ohm, achieved with a parallel of 2*75ohm cable. I simulated the antenna with nec2 engine and the results are very close to the real values.
Thanks to Sandro I0JXX for hardware and Pino IK0SMG for help in matchbox assembling.



Copyright © 2018 SIXITALIA.org. Tutti i diritti riservati.
Joomla! è un software libero rilasciato sotto licenza GNU/GPL.